View Poll Results: Input Shaft Bearing Direction 1st gear side
Plastic shield toward 1st gear
0
0%
Plastic shield toward the engine
0
0%
Voters: 0. You may not vote on this poll
Midland r65 Tranny Rebuiild Question
#1
04-21-2010 | 10:45 PM
Thread Starter
|
Junior Member
Joined: Apr 2010
Posts: 1
Midland r65 Tranny Rebuiild Question
Hello,
I have a 2002 Mini Cooper with the Midland r65 transmission. It has over 120K miles on the original transmission. It began making a noise under load so I purchase the rebuild Kit from MiniMania and everthing is going well on the rebuild. I am ready to re-assemble the transmission but I cannot find which direction to install the input shaft bearing. This is the bearing closest to 1st gear. It has a plastic shield on one side that was destroyed on the old bearing so I have nothing to go by. The manual does not help. The download/step by step instructions do not help - althought they are very good.
Please advise.
I have a 2002 Mini Cooper with the Midland r65 transmission. It has over 120K miles on the original transmission. It began making a noise under load so I purchase the rebuild Kit from MiniMania and everthing is going well on the rebuild. I am ready to re-assemble the transmission but I cannot find which direction to install the input shaft bearing. This is the bearing closest to 1st gear. It has a plastic shield on one side that was destroyed on the old bearing so I have nothing to go by. The manual does not help. The download/step by step instructions do not help - althought they are very good.
Please advise.
Thread
Thread Starter
Forum
Replies
Last Post
